Safety procedures for the Servo robot

The Servo robot is a series of industrial casting machines that hydraulically inject molten metal into a mold under pressure and cool it down to form a solid metal casting after opening the mold. The Servo robot is generally divided into two categories: the hot press chamber Servo robot and the cold press chamber Servo robot. This article focuses on its safety operating procedures, for those who do not know! Here are some answers.

Here is the content list:

• The safety procedures for the Servo robot before it is switched on.

• Precautions for the daily safe operation of the Servo robot.

The safety procedures for the Servo robot before it is switched on.

Firstly, the safety door can not only protect against the occurrence of accidents caused by liquid metal splashes during die-casting but also reduce the occurrence of mechanical injuries and fire accidents, so do not use or remove the safety door at will. Secondly, when opening the Servo robot machine, check whether there are people or debris within the range of movement of the machine, and make sure that no one is there before starting. Thirdly, before switching on the machine. Check the connection fasteners for loose oil and changes in nitrogen pressure, and prevent any fire or heat source from coming near. When maintenance is required, the nitrogen must be discharged first. Fourth, when installing or removing the die-casting mold, the "manual, self-protection, automatic" knob should be turned to the "manual" position for adjustment. Fifth, when the machine has an emergency failure, it must immediately stop, turn off the power, and emergency treatment and maintenance. When there is a fire hazard, the nitrogen in the energy reservoir should be discharged. Sixth, when replacing or overhauling the hydraulic piping components connected to the accumulator, the pressure oil in the accumulator should not be discharged first to make sure there is no pressure before proceeding. Seventh, each time before starting the machine should be cleaned Servo robot machine, especially the machine range of activities at the guide rail, not allowed to have debris and dust and so on. Eighth, check whether the oil level in the lubrication tank is sufficient before starting the machine, and lubricate according to the lubrication schematic and lubrication requirements. Regularly check the lubrication of the automatic lubrication, especially the curved elbow mechanism part.

Precautions for the daily safe operation of the Servo robot.

Always pay attention to the position of the green zone of the oil suction filter's clogging indicator, when it is close to the red zone the filter element must be replaced and cleaned. When the oil temperature in the oil tank exceeds 55°C, stop the machine at the end of a working cycle to check the cause and wait until the oil temperature has dropped before resuming work. When the operator leaves the Servo robot or stops for a long time, the oil pump should be stopped and the power should be switched off after work. Adjust the clamping force to meet the requirements of the die-casting process, try to be smaller and avoid exceeding the nominal clamping force to avoid damage to the clamping machine parts. When the Servo robot is shut down for a long time, it should be thoroughly cleaned up, all the friction surfaces and the places exposed after processing that have not been treated with surface protection should be coated with rust inhibitor, and the nitrogen in the energy reservoir should be discharged, special attention should be paid to the moisture-proofing of the electric oil tank and other electrical components, and the batteries should be energized and replaced regularly according to the relevant regulations.

For more Servo robot-related questions, please contact us. Our official website is https://www.diecastingmachinechina.com/.